Camco Vortex 200V User Manual download pdf (Page 23)

5 OPTIONS

USER MANUAL

VORTEX 6, 4, 2.6 and 200V

P.22

5.1 E.U.I.2 (Extended User Interface)

CAUTION! Always switch off and unplug the VORTEX from mains, before

making alterations to the E.U.I. card.

The E.U.I. card contains the Rear XLR Panel as standard. Other input cards are

available (See 5.1.1 What Are The Possibilities Using The E.U.I.2?).

To remove the E.U.I.2 unscrew the two Phillips head screws at the left and right

end of the XLR-Panel and carefully slide out the E.U.I.2.

To reﬁ t the E.U.I.2, carefully insert it. Pay attention that the cable is not clamped.

ATTENTION! Don’t forget to tighten the screws!

5.1. 1 What Are The Possibilities Using The E.U.I.2?

The E.U.I.2 is a very powerful interface, which allows access to most of the

system parameters, such as volume, input signal, mute, output current, clip

signal, temperature and more. You can use the E.U.I.2 as a ﬁ lter, remote control,

signal processing device and more… Please contact your dealer/distributor or

CAMCO to customise the E.U.I.2 according to your wishes.

5.2 CAI (CAMCO Audio Interface)

CAI is a bus system, in which all signiﬁ cant device functions can be monitored

externally and remotely controlled using a master PC. Up to 99 devices can be

controlled in parallel in each phase of the bus system, which simply consists of

a two-core insulated cable. For more complex operations, the Master can serve

multiple busses. For more information, please contact your dealer or distributor.

CAI allows:

To control the output-level of each Channel independently

(exception: mono modes, only Channel A is affected)

To mute each channel independently

(exception: mono modes, only Channel A is affected)

To switch the VORTEX into Standby (and back again)

To monitor temperature, output-signal, clip, output-current.

5.2.1 Wiring

To connect the VORTEX to your CAI system use a fully-wired telephone-type

cable with RJ12 connectors. For longer distances, use higher grade cable, like

RS485, DMX512 for AES/EBU digital audio. Using the second connector, CAI

signals can be sent to other VORTEX ampliﬁ ers (or to other CAI controlled

devices). A linear network topology is recommended with 100 Ohm termination

at its end. Please refer to RS485 speciﬁ cations.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Camco Vortex 200V User Manual Page 23